What would be the best way to reset / configure this switch?
I have tried the reset procedure shown here (http://www.cisco.com/c/en/us/support/docs/switches/catalyst-2950-series-switches/45383-express-setup.html#trbl6) but even after reboot the switch would only work on a 192.168.0.x subnet. If I connect it to a different one it won´t take / deliver a valid address.
Thanks in advance.
Solved! Go to Solution.
You will have to configure the switch via console cable and apply the address scheme that corresponds to your network on the switch.
I have the cable and serial port on my PC.Used putty but connection screen did not show any prompt character..Was I missing something?
Where could I find instructions as to what commands to type in order to set the right address range?
This should help you out: www.cisco.com/c/en/us/td/docs/switches/metro/me4924-10ge/hardware/installation/guide/hig/HIGQuick.html
I've reset the config and accessed switch over terminal.
It remains the same though. While still connected via the terminal I get this error message in the same network where I had the problem before:
03:56:20: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/16, changed state to up
03:56:20: %SPANTREE-7-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk FastEthernet0/16 VLAN1.
03:56:20: %SPANTREE-7-BLOCK_PORT_TYPE: Blocking FastEthernet0/16 on VLAN0001. Inconsistent ------------------------------------------------------------------------------
Do you have any idea what might be causing this error?
Here is the Config:
Current configuration : 1213 bytes
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
enable secret 5 xx
enable password xx
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
no ip address
no ip route-cache
ip http server
line con 0
line vty 0 4
line vty 5 15
End of Config.
IT Dept. of this rented offices indicated me some time ago to disable Spanning Tree option on the CISCO SF200-48 switch whose network I'm trying to connect this other switch to.
Done. But again got errors.
04:38:13: %SPANTREE-7-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk FastEthernet0/9 VLAN1.
04:38:13: %SPANTREE-7-BLOCK_PORT_TYPE: Blocking FastEthernet0/9 on VLAN0001. Inconsistent port type.
Do you think BPDU Filter will help with this?