Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

reset port settings

lets say i have some configurations on a port and i want to remove all these configurations, i dont wish to use the No command before each line .

how can i remove for example 6 configurations ina single command line ? that is to reset the port to a non configured port

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: reset port settings

hi!

You can use the "default interface giX/X " command in the config mode. It will reset the interface to its defaults.

Regards,

Niranjan.

(pls rate helpful posts)

2 REPLIES
Silver

Re: reset port settings

hi!

You can use the "default interface giX/X " command in the config mode. It will reset the interface to its defaults.

Regards,

Niranjan.

(pls rate helpful posts)

New Member

Re: reset port settings

Thanks Niranjan.

1250
Views
0
Helpful
2
Replies
CreatePlease to create content