Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Resetting 2950c Switch

Have a 2950 switch that was configured by another company. Need to change IP address. Tried resetting the switch via documentation but when pressing the mode button switch led's do not blink. Have done this on other 2950 and 2960 switches without a hitch. Any suggestions on how to reset.

2 REPLIES
Cisco Employee

Re: Resetting 2950c Switch

Hi Jack,

WHY don't you just delete the running config and do "wr mem" and then reload the switch.

Ankur

Re: Resetting 2950c Switch

Hi,

If you are able to login to the switch and you want to change the switch to factory defualts, do the following:

erase nvram:

reload

Let us know if you have any other question.

HTH,

-amit singh

130
Views
0
Helpful
2
Replies