I just recently picked up a Catalyst 2948G and would like to find out the following: 1/ how to reset the unit, and 2/ find out if it is possible to manage the unit through CISCO's Network assistant as i am unfamikiar with the CISCO terminal access. I would truly appreciate some assistance regarding this matter.
CNA only supports IOS switches that is an older catos box. The only way to reset it is thru command line . The "clear config all" command will reset it. If you get the right catos version on it , it can support a gui interface.The image version would have to a "cv" somewhere in the image name which stands for ciscoview.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...