Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Resetting Cisco 2911 to factory settings...

I was recently configuring my Cisco 2911 router through a HyperTerminal session via USB connection.  I noticed when I first connected it told me that there was a 1 time username and password (cisco, cisco) and I should change this or I would be locked out.... sure enough I did not change it and am not unable to log back in with those credentials.

What can I do to reset the system to its factory default or log into the terminal session again to setup the user credentials?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Resetting Cisco 2911 to factory settings...

Password Recovery Procedure for the Cisco 2900 Integrated Services Router
http://www.cisco.com/en/US/products/ps5854/products_password_recovery09186a0080b34901.shtml

Standard Break Key Sequence Combinations During Password Recovery
http://www.cisco.com/en/US/customer/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml

Hope this helps.  Please don't forget to rate useful posts.  Thanks.

1 REPLY
Hall of Fame Super Gold

Re: Resetting Cisco 2911 to factory settings...

Password Recovery Procedure for the Cisco 2900 Integrated Services Router
http://www.cisco.com/en/US/products/ps5854/products_password_recovery09186a0080b34901.shtml

Standard Break Key Sequence Combinations During Password Recovery
http://www.cisco.com/en/US/customer/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml

Hope this helps.  Please don't forget to rate useful posts.  Thanks.

30082
Views
4
Helpful
1
Replies
CreatePlease to create content