Resetting the standby supervisor engine in a Catalyst 6509
Hello, can anybody tell me if there's any consequence of resetting the standby supervisor module in catalyst 6509 witch CatOS?. It's a Dual Supervisor Engine in a chassis. Could this cause disruption in networking operation?.
Re: Resetting the standby supervisor engine in a Catalyst 6509
If your switch is dual SUP and only resetting the standby, it should not cause any traffic interuption.
In regard of the wording in the link from your post, I agree he wording is a bit confusing. However, the document is about recovering an MSFC from ROMMON and the example from the top is a C6500 with single SUP.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...