resilliency between 3550 switches with WAN protocol as BGP
I have a dual hommed scenario at two sites with Cisco 3550 switches i have used the EMI image. The wan protocol used is bgp. I have provided a direct connectivity between the switches for IBGP and a connection to LAN too. I have given all the necessary configurations for BGP but in case of WAN failure of primary switch i could not reach the remote LAN
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...