Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Restart of a 6506

Hi;

I did a "show process events" in a 6506 and it reload-restarted...

The crash ifo has the line: "Address Error (load or instruction fetch) exception, CPU signal 10, PC = 0x4047DB2C"

Is this normal?

The command "show process events" uses so much resources it has to reboot the 6506?

What type of commands are dangerous for a 6506? (so they reboot the system)?

Thanks. Regards

2 REPLIES
Silver

Re: Restart of a 6506

Hi

Address errors occur when the software tries to access data on incorrectly-aligned boundaries; two-byte and four-byte accesses are allowed only on even addresses. An address error usually indicates a software bug, but faulty hardware can also be a cause.

I would try an upgrade to the latest version of your Cisco IOS Software release train.

Hope this helps

Purple

Re: Restart of a 6506

It is obviously a IOS bug if any "show" command causes the box to reload , you can try a newer version or look for bugs on the bug navigator on CCO.

136
Views
10
Helpful
2
Replies