Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Restart SNMP on CatOS

Is there any way to restart all SNMP processes on a Cat6000 switch?

I have tried "set snmp disable" then "set snmp enable" but it is not resolving my problem.

I am trying to pull SNMP info using a port map utility and it always hangs up on one, specific CatOS switch.

3 REPLIES
Silver

Re: Restart SNMP on CatOS

Please give me a "show snmp"

Thanks

Andrea

New Member

Re: Restart SNMP on CatOS

SNMP: Enabled

RMON: Disabled

Extended RMON Netflow Enabled : None.

Memory usage limit for new RMON entries: 85 percent

EngineId: 00:00:00:09:00:d0:97:f1:6c:00:00:00

Chassis Alias:

Traps Enabled: None

Port Traps Enabled: None

Community-Access Community-String

---------------- --------------------

read-only removed

read-write removed

read-write-all removed

Additional- Access-

Community-String Access-Type Number View

-------------------- -------------- ------- -----------------------------------

Trap-Rec-Address Trap-Rec-Community Trap-Rec-Port Trap-Rec-Owner Trap-Rec-Index

---------------- ------------------ ------------- -------------- --------------

Silver

Re: Restart SNMP on CatOS

Have you already tried "set snmp trap enable all"?

All traps are disabled by default and need to be added to the configuration, either individually or by with the all parameter.

Then check with 'test snmp'

HTH

Andrea

375
Views
0
Helpful
3
Replies