Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Retrieve SFP model number Cisco 3750

Dear all,

I have a WS-C3750G-24TS network switch with one SFP module installed. The show inventory raw command displayes the following;

NAME: "GigabitEthernet1/0/25", DESCR: "1000BaseSX SFP"

PID: , VID: 255, SN: FNS0928G0FE

SW61#sh interface gigabitEthernet 1/0/25 capabilities

GigabitEthernet1/0/25

  Model:                 WS-C3750G-24TS

  Type:                  1000BaseSX SFP

  Speed:                 1000

  Duplex:                full

  Trunk encap. type:     802.1Q,ISL

  Trunk mode:            on,off,desirable,nonegotiate

  Channel:               yes

  Broadcast suppression: percentage(0-100)

  Flowcontrol:           rx-(off,on,desired),tx-(none)

  Fast Start:            yes

  QoS scheduling:        rx-(not configurable on per port basis),tx-(4q2t)

  CoS rewrite:           yes

  ToS rewrite:           yes

  UDLD:                  yes

  Inline power:          no

  SPAN:                  source/destination

  PortSecure:            yes

  Dot1x:                 yes

NAME: "GigabitEthernet1/0/25", DESCR: "1000BaseSX SFP"
PID: , VID: 255, SN: FNS0928G0FE

SW61#sh interface gigabitEthernet 1/0/25 capabilities
GigabitEthernet1/0/25
  Model:                 WS-C3750G-24TS
  Type:                  1000BaseSX SFP
  Speed:                 1000
  Duplex:                full
  Trunk encap. type:     802.1Q,ISL
  Trunk mode:            on,off,desirable,nonegotiate
  Channel:               yes
  Broadcast suppression: percentage(0-100)
  Flowcontrol:           rx-(off,on,desired),tx-(none)
  Fast Start:            yes
  QoS scheduling:        rx-(not configurable on per port basis),tx-(4q2t)
  CoS rewrite:           yes
  ToS rewrite:           yes
  UDLD:                  yes
  Inline power:          no
  SPAN:                  source/destination
  PortSecure:            yes
  Dot1x:                 yes

How can I know if the SFP supports Multi Mode (MM) or Single Mode(SM) or is there a way to retrieve the SFP model somehow?

Best regards,

Wim

1 REPLY
VIP Purple

Re: Retrieve SFP model number Cisco 3750

You can find it by looking at the description of the SFP module in this output.

SX - Short Wavelength ( ie Multi Mode module)

LX - Long Wavelength (ie Single Mode module)

In your case it appear as below which indicating it is MM SFP module.

"DESCR: "1000BaseSX SFP"

Here  is some reference to this (old but still valid)

http://www.cisco.com/en/US/tech/tk389/tk214/tech_brief09186a0080091a8a.html

HTH

Rasika

**** Pls rate all useful responses ****

808
Views
0
Helpful
1
Replies