I was playing with reverse routing and noticed the following behaviors
1)it can't deal with permit ip any any? Exact From subnet --> To subnet required
2)the created static routes are not the same as usual static routes? see below
SPOKE -- HUB1
|
|
HUB2
HUB1 and HUB2 are connected and talking RIP.
Dynamic tunnel terminates on HUB1
I do a ping from SPOKE_IP to a loopback LOO on HUB2
thus traffic goes via SPOKE to HUB1 to HUB2
I see that a static route is created on HUB1. The route is redistributed in RIP and available on HUB2.
But from HUB1 I can't ping SPOKE_IP while it is possible via HUB2 which passes HUB2