Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Reverse Telnet to a console

Hi,

I have a 2621 router and a 2651XM router. Currently, the 2651XM router is defective. Is there a way to telnet to the console of the 2651XM using reverse telnet on the 2621 on port 2065 (AUX). I connected a rollover cable from AUX of 2621 to the console port of 2651XM. Please tell me if this is possible.

John

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Reverse Telnet to a console

Hi,

Yes it is, under the line aux of the 2621 add the following commands:

transport input telnet

stopbits 1

no exec

then do "telnet x.x.x.x 2065", where x.x.x.x is an active IP on the 2621.

HTH,

Mohammed Mahmoud.

3 REPLIES

Re: Reverse Telnet to a console

Hi,

Yes it is, under the line aux of the 2621 add the following commands:

transport input telnet

stopbits 1

no exec

then do "telnet x.x.x.x 2065", where x.x.x.x is an active IP on the 2621.

HTH,

Mohammed Mahmoud.

Re: Reverse Telnet to a console

Thank you very much Mohammed. I can now reverse telnet to the console. I don't know what I did wrong before. My configuration was just the same but now it is working. At least you verified that this is possible and your config helped me a lot. Thanks.

Re: Reverse Telnet to a console

John,

You are very welcomed :), i am glade i helped, and thank you for using the rating system.

BR,

Mohammed Mahmoud.

305
Views
0
Helpful
3
Replies
CreatePlease login to create content