Thanks for reading and I hope you all have a very merry Christmas
I have a new 877 that I am using for internet traffic for 3-4 internet only devices.
I also have a clean network that i want to insure no cross contamination. However I plan on rolling this out to many sites, but for management I was hoping to set up a reverse telnet to the console port from our one of my clean switches. which should allow me to keep the units seperated and allow me to manage changes etc remotely.
Unfortunatly there is no Aux port on the clean switch (3560). Is there still a way to acheive this? can i configure one of the ethernet ports to connect to the console of the 877?
By "clean" network, do you mean that there is no routing or physical connection at all between the clean network and the internet-only 877? If so, then no. there's no way to gain out-of-band access to the 877 without a modem. You also cannot configure an ethernet port to connect to a console port.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...