Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RIP Network Advertise??

Hi,

I have 3 Router connected via Serial interface i.e. R1 , R2 and R3 now I want to Network Advertise in unicast from Router R1 to R3 without using following things how I can do pls help me..

neighbor command/ PBR/ Static or Default Route/ Redisribution.

4 REPLIES
Hall of Fame Super Silver

Re: RIP Network Advertise??

Hello Abnhinay,

what about running RIP over a point to point GRE tunnel between R1 and R3?

Hope to help

Giuseppe

New Member

Re: RIP Network Advertise??

sir,

sorry in last qus. i forget to mention Tunnel also. we cant use tunneling. any another one..plsss

Re: RIP Network Advertise??

If unicasting is not a contraint between R's, then we could use ip multicast helper-map..-:)

New Member

Re: RIP Network Advertise??

Hi,

I got it its working via below steps:

If any query pls revert once..

!
interface Serial0/0
ip address 10.10.10.1 255.255.255.0
ip nat outside
ip virtual-reassembly
serial restart-delay 0
clock rate 64000
!
!
!
!
router rip
version 2
network 1.0.0.0
network 10.0.0.0
!

ip nat outside source static udp 12.12.12.2 520 224.0.0.9 520 extendable
!
!

260
Views
0
Helpful
4
Replies
CreatePlease login to create content