Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

rip problem

Hi.

I'm trying to solve one lab and i have problem with rip.

there are 2 routers (let's call them R1 and R2).

R1 have learned routes to networks 10.1.1.0/24, 10.1.2.0/24 etc.

R1 does not propagate this routes to R2.

There is rip v1 between the routers,

there is network 10.1.128.0/23 between the routers.

what can i do to get this routes from R1 to R2?

I must use rip version 1, i can't change addresses, subnet masks, I can't use any sumarization technique.

any ideas?

thanx

1 REPLY
New Member

Re: rip problem

Hi,

Sine you are using classless networks, there is no other way than configuring this as RIPV2.

Try RIPV2 if you can..

Rgds

107
Views
0
Helpful
1
Replies