The task at hand can be better understood if we get to see the network topology.
If you enable RIP on a major network, for instance:
and you have IP interfaces on 10.1.0.0/24, 10.2.0.0/24 and 10.3.0.0/24 - but you only want interface 10.1.0.0/24 to send RIP updates, you need to use the passive interface command on router rip process pointing to the interfaces holding the other addresses.
Peering is often mentioned with BGP. You don't peer in RIP, you send and receive RIP updates. There is no concept of 'neighbors', event though you use the neighbor command :)
There isn't a command in IOS to know what is your RIP neighbor unless you have your network topology at hand. With other routing protocol, you will know what routers you have a relationship with.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.