I am trying to get connected from an ATM machine which has an RJ45 port to a switch. I cannot run a CAT cable between these two, the only line i have between them is a telephone line. Any suggestions on how i can get these two connected through the telephone line.
If the line is a reasonable distance, i.e. 300 ft or less, you can clip the RJ-11 connectors off of the cable and crimp on RJ-45 connectors. You'll have 2 pairs in standard RJ-11;wire them straight through using 1,2,3,6 on the RJ-45 connectors.
If there is only one pair then you're out of luck.
It is going to have to be a short run back to the switch on telco wire and it will have to run 10 meg , it certainly won't run 100 meg and may not work at all . The only other option you would have would be to buy one of the LRE switches which is basically ADSL I believe which will go longer distances on telco wire .
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...