Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

RMON configuration

I'm trying to configure a RMON event to create a trap/syslog message when the CPU utilization exceed 60%.. I created this config, but when I try to load it to the router I'm getting the error message " Failed to create alarm"

rmon event 1 log trap public description "High CPU utilization" owner admin

rmon alarm 10 1.3.6.1.4.1.9.9.109.2.0.1 60 absolute rising-threshold 60 1 falling-threshold 40 owner admin

The first command goes in fine but the second create the error message.. What am I doing wrong?

1 REPLY
Silver

Re: RMON configuration

You need the .0 at the end of the OID just like using the command snmp get need actual MIB instance.The Object ID should look like

10 1.3.6.1.4.1.9.9.109.2.0.1 60.0.

301
Views
0
Helpful
1
Replies
CreatePlease to create content