During the testing, a loopback address was added to a C6k box (running 12.2(18)SXF7). This loopback interface was marked as 'passive' within IS-IS and was entered into the IS-IS topology database and advertised to all other IS-IS peers. Subsequently, the loopback interface was removed (and configrmed with 'sh ip route', etc), but the route is still present in the IS-IS topology, and is being advertised to the rest of the network. Is there any way to remove this rogue host route without a restart of IS-IS on the box advertising the route?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...