Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

rommon Command Line

Hi I'm configuring a CatOS L3 card and I'm trying to hit the L3 management port in the L3 console port of a 4006 switch card and I'm getting an "rommon" prompt for both my l3 cards. I'm not great w/ caralyst. Any ideas on how to get to the normal router prompts? Thanks.

1 REPLY
Silver

Re: rommon Command Line

Hi ,

Please check the below link for Recovering a Catalyst 4000 Layer 3 Module (WS-X4232-L3) from a Corrupted or Missing Image, or from ROMmon Mode

http://www.cisco.com/warp/public/473/130.html.

Below link for 4006 switch recovery from rommon mode.

http://www.cisco.com/warp/customer/473/26.html#cat4k

Hope it helps you alot ..plz rate it..

Thanks,

satish

270
Views
0
Helpful
1
Replies
CreatePlease to create content