Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

rommon in 2960G

hello,

I have 2960G that in rommon status.

I need that the switch work in 0x2102 (regular mode).

I don't have a backup to configutratuio in my PC.

I do wr before the switch go to rommon (startup config).

What to do in order to the switch will be in 0x2102 (regular mode) with the same configuration( before the switch go to rommon)?

thanks...

Everyone's tags (1)
1 REPLY

rommon in 2960G

Hi,

Can you please verify whether it is rommon or switch; prompt.

If it is in switch: prompt then follow the below.

switch:flash_init

switch:load_helper

switch:dir flash:

If you are able to see any IOS image in the flash then issue the below.

switch:boot flash:(image name)

Thanks

525
Views
0
Helpful
1
Replies