Anyways, my sup engine uses bootflash. I have tried already that command but to no avail. The error that i have posted in my first post still appears and continues to cycle.
I am thinking of copying another IOS into the flash. Can i use tftp on rom monitor? I tried xmodem but it didnt work. I tried assigning an ip address to the management interface but i cant ping it! sigh ill do all these again on monday. I need all your suggestions thank you
Before you try anything else I would suggest removing all the line cards, reseating the SUP and the DRAM. Then try booting with just the SUP and no line cards. Try to recover the SUP without any linecards in the chassis.
If it still doesn't work (after you have followed the steps for recovery from rommon as mentioned in the documents in the previous post), its HW failure.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.