Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Route for 2 provider

Hi. I have gw2821 and 2 internet provider. Lan 10.10.10.0/24.

As to me make for IP 10.10.10.0-10.10.10.100 use 1 provider, and ip 10.10.10.101-10.10.10.254 use another provider?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Route for 2 provider

Hi Slava,

Seems you guys need to use PBR functions and correct NAT commands on each interfaces.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&topicID=.ee71a06&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dded2da

Just modify the configuration I provided to beat your requirement.

Hopes this helps

Thot

1 REPLY

Re: Route for 2 provider

Hi Slava,

Seems you guys need to use PBR functions and correct NAT commands on each interfaces.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&topicID=.ee71a06&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dded2da

Just modify the configuration I provided to beat your requirement.

Hopes this helps

Thot

117
Views
0
Helpful
1
Replies
CreatePlease to create content