Hello sir, how are you?
Im now configure a UC560 voip with 8 vlans.
I would like configure 2 WAN channels to vlans, 1 route to WAN to vlan of voip, 10.10.x.x and other route to WAN to others vlans 172.16.x.x
So, the command to voip is ip route 10.10.x.x 255.255.252.0 (IP OF WAN), and the command for the others vlans is the same with the other ip of vlan and ip of wan.
But, how can ensure the others vlans dont will navigate over the wan of voip ? Need put acl or just put route?
In this example, will I have delay on this "proccess" to select the route ?
Thanks!