route-map does not apply or appear in running conf
Hi Guys n Gals,
I am having an issue with applying a route-map to an SVI to route certain traffic via a redundant link.
The route-map is configured as follows,
access-list 101 permit ip host 10.2.10.14 host 10.1.10.10
access-list 101 permit ip host 10.2.10.14 host 10.1.10.11
access-list 101 permit ip host 10.2.10.14 host 10.1.10.12
route-map CLAN_LON permit 10
match ip address 101
set ip next-hop 192.168.102.20
Very simple as far as I am concerned.
The hardware is a WS-C3750G-24TS running c3750-advipservicesk9-mz.122-25.SEB4.
When applying to the SVI the command is accepted, but not applied. I have checked the usual things such as case etc.
When first configured it did apply and was working ok, but vanished from the configuration about 3 months ago.
I have checked the bug tool kit and there is a bug on the version which does not write the PBR function into hardware, but this was working. Have rebooted the device in case the bug had caused it, but it still would not apply.
Has anyone experienced this issue also? At the moment I am going along the lines of a IOS upgrade, but I would like to see if it is something else first as this would require scheduling/more downtime etc....
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.