Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Route-Map sequence Number

           Hi all,

                Good Morning!

Need    to confirm config of route-map below.

I created ACL  113

access-list 113 permit tcp any any eq www

Then i created route-map for it

route-map policy permit 10

match ip address 113

set ip next-hop 2.2.2.2

Now i created ACL

access-list 114 permit tcp any any eq 443

access-list 114 permit tcp any any eq telnet

Now i created route-map for this without any sequence number

Will this work now without sequence number 20?

When i do

sh route-map

route-map policy, permit, sequence 10

Match clauses:

   ip address (access-lists): 113 114

Set clauses:

   ip next-hop 2.2.2.2 3.3.3.3

Policy routing matches: 0 packets, 0 bytes

it shows both acl 113 and 114 need to know if this route-map config will work or not?

Thanks

MAhesh

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Route-Map sequence Number

Hello Mahesh,

yes I do mean that

Hope to help

Giuseppe

4 REPLIES
Hall of Fame Super Silver

Re: Route-Map sequence Number

Hello Mahesh,

your configuration performs a logical OR of the two IP ACLs

if a packet matches ACL 113 or it matches ACL 114 the PBR action of setting an ip next-hop will take place.

The configuration is correct if you need to use the same IP next-hop for both types of traffic, otherwise you need a new route-map clause with a different sequence number and a different set action.

Edit:

actually there are two IP next-hops defined in the set section, in this case first next-hop is used and if it is unavailable ( no ARP entry) the second next-hop will be used. The action as described above applies to traffic matching  one of the two ACLs.

if you want to have different IP next-hops you need two route-map clauses/blocks

Hope to help

Giuseppe

New Member

Route-Map sequence Number

Hi Giuseppe,

When you say

if you want to have different IP next-hops you need two route-map clauses/blocks

Does it mean route map with 2 sequence numbers say 10 and 20?

Thanks

MAhesh

Hall of Fame Super Silver

Route-Map sequence Number

Hello Mahesh,

yes I do mean that

Hope to help

Giuseppe

New Member

Route-Map sequence Number

Hi Giuseppe,

Thanks again.

Seems need to learn lot from this forum.

Regards

MAhesh

1526
Views
0
Helpful
4
Replies