Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Route-map to change BGP attributes for Specific route

Hello,

 

I'm trying to build a route-map that would take a route learned via BGP from an upstream peer, apply a local preference change to just this route, and leave all other routes unchanged.  I've tried a few options in my lab, however it seems to change the route I'm matching via ACL and dropping all other routes I'm assuming due to the implicit deny.  I figured then a prefix list would work but that doesn't seem to be the case either.  Any ideas?  

 

-Chris

  • LAN Switching and Routing
Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Hello Chris,this is a case

Hello Chris,

this is a case for using an empty last block in the route-map

route-map CHANGEONE permit 10

match ...

set ...

route-map CHANGEONE permit 20

 

! emply final clause just to permit all the other routes

 

Hope to help

Giuseppe

 

 

 

 

2 REPLIES
Hall of Fame Super Silver

Hello Chris,this is a case

Hello Chris,

this is a case for using an empty last block in the route-map

route-map CHANGEONE permit 10

match ...

set ...

route-map CHANGEONE permit 20

 

! emply final clause just to permit all the other routes

 

Hope to help

Giuseppe

 

 

 

 

New Member

Thank you very much!

Thank you very much!

65
Views
5
Helpful
2
Replies