I have 1 cisco router 3945, i configure 2 gigabit if 0/1 and 0/2, below the if 0/2 i have many sub-if (vlans), linked to a same number of route maps and acl's to make the router send the packet to a specific destination for each one; today a activate the if 0/0 to do the same thing, but after configure all of it (Sub-if,acl and route map) i see the acl and route map does not match with the ip addresses i configure into the acl. Why if i send the traffic trough the old if 0/2 it works, but when a try to do the same thing trough the new if 0/0 it doesn't?.
Please anyone can help me?
