Hi all, If I set an ip next hop for a network, does that router have to be local to the one where the route maos on, or can it go via a number of routers until it reaches the one stated in your route map ?
assume that you wanted to reach "Network D" from ur "Network A", which is connected like A-->B-->C-->D. since your "Network A" router is not directly connected to "Network D" you can put a Network route like to reach "Network D" go via "Network A's" serial port or juz specify "Network B's" serial port IP.
Serial 0 192.168.1.1/30
Serial 0 192.168.1.2/30
Serial 1 192.168.2.1/30
Serial 0 192.168.2.2/30
Serial 1 192.168.3.1/30
Serial 0 192.168.3.2/30
in this scenario u can route map like as follows on Network A router.
say Router A is connected to Router B and Router C.
now if you want to route a specific source network from Router A to router B only, you will apply route map on Router A and set next hop IP with the IP of Router B interface which is connecting to Router A.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...