Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Route summarization for is-is

Hello all,

I have a question it will be very easy for all of you but i could not configure it on gns and packet tracer. I am new for cisco. There area 2 area for is is.In area 1, there are 2 L1 routers and one of them have 2 loopbacks 192.168.1.0 and 192.16.2.0 and then i am trying to summarization on L1-L2 router for area 2. in area 2, there are just 2 routers and one of this L1-L2(R1), other one is L1 router(R2). When i did this summarization,

Which router's routing table will be reduced compared to the routing table before the summarization?

My idea is that both of it. But in the text book, it is saying that t just R1. Could you explain it?

Thank all of you

1 REPLY

Route summarization for is-is

your question is not much clear. Please post the configs or a diagram. it will help to give answer easily.

regards

C

87
Views
0
Helpful
1
Replies
CreatePlease to create content