I believe that Michael is correct in identifying both modules as layer 2 switches. And as such the layer 2 switch can not provide routing.
However the module is generally inserted into a router which does provide routing. So if you configure 1 or more VLANs, assign ports to the VLANs, and configure VLAN interfaces with IP addresses, then the router in which the module is inserted should provide routing for the devices connected to the layer 2 switch module.
It seems to me that the link you provide gives confirmation to the answers that we already gave you. On both modules that you ask about in the table it clearly says that layer 3 switching (routing) is done on the router and not in the switch module. The modules that it indicates can do layer 3 switching in the module are: EtherSwitch Service Modules (NME-16ES-1G, NME-16ES-1G-P, NME-X-23ES-1G, NME-X-23ES-1G-P, NME-XD-48ES-2S-P, and NME-XD-24ES-1S-P and these are not the modules that you asked about.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...