Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Router 2811 / when restart lose the configuration

I apply the configuration in the router, save, copy run to star, review the config and all work ok, but when restart the router lose the configuration and ask if I want enter the initial configuration.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Router 2811 / when restart lose the configuration

Walter,

This is more than likely from a previous password recovery. Your configuration register was probably not set back to the correct setting afterwords. Check out the link below to fix the configuration register.

0x2102 is the setting that you want.

http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml

HTH,

Mark

2 REPLIES

Re: Router 2811 / when restart lose the configuration

Walter,

This is more than likely from a previous password recovery. Your configuration register was probably not set back to the correct setting afterwords. Check out the link below to fix the configuration register.

0x2102 is the setting that you want.

http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml

HTH,

Mark

New Member

Re: Router 2811 / when restart lose the configuration

Thanks Mark, my issue is solved

503
Views
0
Helpful
2
Replies
CreatePlease to create content