Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

router and layer 2 switch, etherchannel

Hi everybody

Please consider the following scenario

  internet------  Router f0/0------------------------------f1/1SW-----------rest of network

                                f0/1-------------------------------f1/2

hosts located in " rest of network" uses Router as a default gateway to reach internet.  Sw is a layer 2 switch. We want to establish a etherchannel between routers routed ports f0/0,f0/1 and sw acess ports f1/1,f1/2. So our etherchannel will have l3 ports on one side( at router) and l2 accessports at sw side.

We want to use PagP to form etherchannel.

I configured sw for etherchannel as:

int range f1/1-2

switchport access vlan 1

channel-protocol  PagP   ( do i need this command ? )

channel-group 1 mode desirable.

Now how do we configure router for etherchannel? the port channel should be configured with ip 199.199.199.1/24 which is the default gateway for hosts located in " rest of network".

thanks and have a great weekend.

  • LAN Switching and Routing
Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions

router and layer 2 switch, etherchannel

Hi Sara,

i found a better example/template for you

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_example09186a00800ef797.shtml

Have a great week end you too

Alessio

2 REPLIES

router and layer 2 switch, etherchannel

Hi Sara,

i found a better example/template for you

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_example09186a00800ef797.shtml

Have a great week end you too

Alessio

Bronze

router and layer 2 switch, etherchannel

Thanks Alessio

3178
Views
0
Helpful
2
Replies