On most devices, you can usually load an IOS via the console cable; don't know if the converse is supported by it too.
Much faster to use a network connection. At the minimum, could could Ethernet to interconnect a single PC with the router. A command simmilar to "copy flash: ttcp: | ftp: | rcp:" should prompt you for IOS name and ttcp or ftp or rcp server address and then copy your IOS to it.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...