Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router config

This is a simple one. how how I reduce the time so the the telnet session won't time out on me?

Also, how do I get the router not to display or echo a statement after I do any modification. For example, after I change the configuration on an interface, the router echos the following: *Nov 30 09:14:25: %SYS-5-CONFIG_I: Configured from console by cisco on console". How do I disable the router from displaying this?

Thanks in advance,

sK

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Router config

For changing the telnet timeout. Try the following:

Router(config)#line vty 0 4

Router(config-line)#exec timeout 30

The 30 in the above statement is idle minutes before disconnect.

To remove any messages, type the following:

Router(config)#no logging monitor

HTH and please rate.

4 REPLIES

Re: Router config

For changing the telnet timeout. Try the following:

Router(config)#line vty 0 4

Router(config-line)#exec timeout 30

The 30 in the above statement is idle minutes before disconnect.

To remove any messages, type the following:

Router(config)#no logging monitor

HTH and please rate.

Hall of Fame Super Bronze

Re: Router config

Actually, the command is

no logging console

no logging monitor affects all monitored connections which include any SNMP logging traps among other things.

New Member

Re: Router config

You are correct. The no logging monitor didn't work but the no logging cosole worked.

Thanks,

sK

Re: Router config

no logging monitor will shut off the messages during a telnet session and you got the console one figured out.

131
Views
0
Helpful
4
Replies