Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

router configuration

Hi. i saw below statement in my router.  May I know why use this command?

1) why need to boot startup-config from flash instead of NVRam? any advantage?

boot-start-marker

boot config flash:startup-config

boot-end-marker

2) why need to set card type.  If my fastethernet 0/1 is 10M Internet and fastethernet0/0 is local LAN, Interface serial0/0/0:0 is 2M MPLS connection?

card type e1 0 0

1 ACCEPTED SOLUTION

Accepted Solutions

Re: router configuration

Alan.

As I mentioned, that command in needed to let the router know what card type you are going to use with that module.

Without that command you could not see the interface s0/0/0:0

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"
3 REPLIES

router configuration

Hi Alan.

1) Booting from flash has the same result. In flash you can store more config files than in NVRAM in case you should roll back to a prevoious configuration version version

2) To activate E1 Controller you need that command

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"
New Member

Re: router configuration

For 2. Activate e1 controller. Does it affect the bandwidth on each interface?

Sent from Cisco Technical Support iPhone App

Re: router configuration

Alan.

As I mentioned, that command in needed to let the router know what card type you are going to use with that module.

Without that command you could not see the interface s0/0/0:0

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"
134
Views
0
Helpful
3
Replies
CreatePlease to create content