Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router-in-a-stick inter-Vlan routing

Hello,

I'm using a Cisco 1720 with 12.2(2) IOS

And the following command on the subinterface give an error:

encapsulation dot1q 1

Encapsulation command is available but with no parameters and it's not accepted alone.

Is there any way to so that?

Regards,

Omar

6 REPLIES

Re: Router-in-a-stick inter-Vlan routing

Hi

try with the native keyword and check.

Thanks

Mahmood

New Member

Re: Router-in-a-stick inter-Vlan routing

Once I use '?' the encapsulation exists but:

encapsulation ?

gives me that the command is incorrect.

New Member

Re: Router-in-a-stick inter-Vlan routing

could you try upgrading from 12.2 to a newer IOS?

New Member

Re: Router-in-a-stick inter-Vlan routing

The only available RAM and Flash permitted me to go through 12.3(18)a

And the same problem I'm encountering.

Blue

Re: Router-in-a-stick inter-Vlan routing

Hi:

You need the IP PLUS image at least to set encapsulation protocols on a 1720.

HTH

Re: Router-in-a-stick inter-Vlan routing

Hi,

Can this be the cause -

IEEE 802.1Q VLAN Routing - No on 1720 router -

http://www.cisco.com/en/US/prod/collateral/routers/ps221/ps223/prod_end-of-life_notice09186a0080147795.html

191
Views
0
Helpful
6
Replies