Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Router IOS

Dear all,

We are using cisco 3632 DCN for out transmisssion equipment network.

Now after IOS upgradation We found output of show ver as follows

#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C3631 Software (C3631-TELCO-M), Version 12.2(11)T10, RELEASE SOFTWARE (fc3)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2003 by cisco Systems, Inc.

Compiled Sat 25-Oct-03 10:45 by eaarmas

Image text-base: 0x60008940, data-base: 0x60FFA000

ROM: System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1)

# uptime is 3 days, 7 hours, 55 minutes

System returned to ROM by bus error at PC 0x0, address 0x0

System restarted at 01:52:24 IST Sun Jan 21 2007

System image file is "flash:c3631-telco-mz.123-14.T7.bin"

as u can see it show IOS as 12.2(11)T10 and system image file is flash:c3631-telco-mz.123-14.T7.bin

what does it mean

Regards

2 REPLIES

Re: Router IOS

Hi there,

Most probably, the 12.3 image has a problem, which caused the router to reboot and use another image from the flash, which was indicated by:

"System returned to ROM by bus error at PC 0x0, address 0x0"

Troubleshooting Bus Error Crashes

Cisco IOS Software Loaded Does Not Support Installed Hardware

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_tech_note09186a00800cdd51.shtml#doesntsupport

Best regards,HTH,

Mohammed Mahmoud.

New Member

Re: Router IOS

Thanks mohammed,

But tell me the solution of this problem

how can i ignore problem on next reload

B'se last time when I have reloaded it has gone in boot loop. and I have to insert IOS via Xmodem

Regards

Mahesh

141
Views
0
Helpful
2
Replies
CreatePlease to create content