I have have a WIndows 2008 NTP server running on my LAN and a test 1841 router and the router was syncing it's time fine, until I had to move the server to behind an ASA firewall. I have opened up UDP/123 in each direction, but it still isn't updating. If I use "debug ntp all" the router never shows anything in the console view.
This is all I have in the config:
ntp server 10.100.1.33
Any ideas, can I force it to go an update as I know it by default take a while?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...