Where are you plugged in ? If you are plugged into the AUX port you will not see anything until the router is totally booted which is why we always use the console port to config because you can see the whole boot process via the console port.
Yes, I was plugged in the Console port. Everything was fine and I had reloaded the router many many times but now it won't show the POST info. Also, when I try to setup a password on the console, it won't apply it.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...