Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router Question

Hi,

Have a question regarding a router. If I have a router configured with interface 0 (192.168.51.0/24)and 1 (192.168.52.0/24) as LAN interfaces and 1 WAN interface. What needs to be done so LAN on interface 0 and 1 can see each other?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Router Question

Hi Friend,

When you say lan interfaces can see each other do you mean interface 0 should be able to comunicate with interface 1 and vice versa?

If yes if you issue a command "sh ip route" you will see both the subnets available in your routing table as directly connected provided "ip routing" is enabled which is by default enabled on cisco routers.

If ip routing is enabled then they should be able to communicate with each other without any additional configuration from your side.

HTH

Ankur

*Pls rate all helpfull post

1 REPLY
Cisco Employee

Re: Router Question

Hi Friend,

When you say lan interfaces can see each other do you mean interface 0 should be able to comunicate with interface 1 and vice versa?

If yes if you issue a command "sh ip route" you will see both the subnets available in your routing table as directly connected provided "ip routing" is enabled which is by default enabled on cisco routers.

If ip routing is enabled then they should be able to communicate with each other without any additional configuration from your side.

HTH

Ankur

*Pls rate all helpfull post

102
Views
0
Helpful
1
Replies