Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router/Switch config

I would like to know what is the best configuration to connect 2 Routers 7206 to 2 Switches 3750 . The best configuration between Routers , between Switches and between Routers/switches . Thanks .

2 REPLIES
Silver

Re: Router/Switch config

Hi ,

Go for HSRP between routers and switches..

We can achieve redundency if you go for HSRP.

Thanks,

Satish

Re: Router/Switch config

HI, [Pls Rate if Helps]

Apart from HSRP, you can also use OSPF to vary the Primary Links & Secondary Links between the Switches & Routers. Using "COST" as a Variation factor.

OSPF - IEEE Standard Protocol.

Between Routers:

You can create a "AS" & maintain a IBGP Sessions (or) you can also create a GRE Tunnel.

Between Switches:

You can use OSPF single area "area 0"

1st Switch: Cost 10

2nd Switch: Cost 100

Between Routers & Switches:

OSPF can be used. But, you need to redistribute the BGP AS into OSPF network using Route-Map command.

PLS Rate if Helps

Best Regards,

Guru Prasad R

108
Views
0
Helpful
2
Replies
CreatePlease to create content