Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ROUTER SWITCHPORT´S

I am doing a simulation on Packet Tracer but there is one configuration i don´t see quite clear.

I  connected a Multilayer_switch to a Router trough a four switchport pannel the router has. Then i did connection redundancy between the MLS and the router using two links, and im trying to configure EtherCannel Layer 2 with them. The problem is the router switchport´s do not take the "channel-group" command, so i don´t know how to do it, or if it can be done at all.

 

Thank you.

1 REPLY
New Member

Try to test on real equipment

Try to test on real equipment. 

Packet tracer is for basic commands. GNS is good but no switch support(

39
Views
0
Helpful
1
Replies