Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

router to pc connection

why we require cross over cabla to connect pc to router? is it related to DTE/DCE concept,if yes then please elaborate in which cases router acts as dte n dce?

thankinh u.......

1 REPLY
Cisco Employee

Re: router to pc connection

Hello,

The reason is because, from physical connections perspective, both are

hosts. So, on all hosts (legacy hosts), the underlying hardware was designed

such that transmitter/receiver pins were fixed. So, when you connect router

to host, if you use a straight-through cable, the transmitters were

connected to transmitter and receivers were connected to receiver. This will

not help in establishing a meaningful communication. On the other hand, if

you use a crossover cable, the cables are flipped, so the transmitter of one

host is connected to receiver of the other host and vice versa.

However, most of the current hardware try to detect the cable and change the

pin role in software (Driver). This feature is called MDIX.

Hope this helps.

Regards,

NT

182
Views
0
Helpful
1
Replies
CreatePlease to create content