If you want all the vlan traffic to be routed via ASA for internet, then point the default route on the router to the ASA IP. On ASA configure the reverse static routes as mentioned in my previous posts. Once that's is done then you will be OK to access the internet via ASA.
i am doing the same config at my customer place. for vlan config customer requirment is 2 router (1841) , i hv configure vlan but not able to connect 2 routers back to back . hsrp is enable , i can't ping router to router.
I am very confused with your config. You say that FA0/1 is 192.168.60.1 and is connected to your ASA, but in the config the IP address of FA0/1 is 172.16.15.2. Also, the access lists that you have applied to FA0/1 preclude anything from coming to or from 192.168.60.1, wherever that is - it's only allowing UDP from the host 192.168.60.2.
Also, what is the config on your ASA? Perhaps you have ICMP not being allowed on the inside interface?
I'm also confused as to why you are running RIP and also have static routes for the same networks.
Perhaps a diagram might be useful so that we can see what you are trying to achieve.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...