Nowadays i'm working on my own lab at the office, before installing the equipment. My problem is the routing between the Catalyst 3750x and the Firewall Fortinet connected to my ISP (Service Provider/Internet).
I have briefly set on Catalyst 3750x :
Enable Routing :
interface vlan 10
ip address 192.168.10.254 255.255.255.0
switchport mode access
switchport access vlan 10
The Port (Giga 1/0/24) thats connect to my Fortinet
ip address 192.168.100.1 255.255.255.0
Then add a default route to Fortinet Interface (Internal) Next Hop:
ip route 0.0.0.0 0.0.0.0 192.168.100.2
On my Laptop:
IP 192.168.10.10 / 255.255.255.0
Gateway 192.168.10.254 (Interface VLAN 10)
DNS Ex. 220.127.116.11
When I do ping to my Gateway 192.168.10.254 .. it Works !!
When I do ping to Catalyst Interface that connects to Fortinet 192.168.100.1 .. it Works !
But , when I do ping to Fortinet Interface .. Fail !!
The switch catalyst can ping fortinet interface 192.168.100.2 , and fortinet can ping
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...