I have been trying to figure this out for a while, hopefully someone here can help me out.
I have a Public class C. I want to take a /27 and route it through a VPN tunnel to another location so that other location can use the public IPs. I have Cisco 2811 Routers at both ends.
I can setup a site-to-site VPN connection on the routers but its figuring out how to route the traffic through so that the /27 comes out on the other end and the machines that communicate on the other end come out using the /27.
/27Subnet --> 2811 <VPN> 2811 --> Hosts
Hosts --> 2811 <VPN> 2811 --> /27 Subnet
Bidirectional communication. I can use internal 10.x.x.x subnet if needed to route between them, and I was thinking of setting up some sort of NAT, but not sure if it will work.
Anyone have any ideas on how to accomplish this? Thanks in advanced.
Thanks for the response. I think I am missing what to actually place in the access-list for the VPN tunnel, and I don't even know if this configuration is correct. Here is what I have so far on my router that has the public IP's:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.