router eigrp 1@? - I am only receiving the default route from ISP via BGP. Do I also want to redistribute BGP into EIGRP? network #.#.#.16 0.0.0.7 - (test subnet supplied by ISP) network 10.10.0.0 0.0.15.255 - Eliminates the need for statics
(layer2) - many connections to business partners (BP)
ASA5545x - Has EIGRP to Router and to (layer 3 switch)
I have created vlan subinterfaces on ASA for testing
I also created a sub-interface for the test subnet supllied by ISP
My eigrp on ASA looks like the following. Does this look correct?
router eigrp 1@? no auto-summary network 10.10.0.0 255.255.240.0
network #.#.#.16 255.255.255.248 passive-interface default no passive-interface inside
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...