Routing between vlan"S

[98765432110A]

Hi

if you have

Router-----Switch-------clients/phone manager

say the clents are on 192.168.0.0 /24

and the phone manager is on 192.168.1.0/24

how can i make it so that clents can access the phone manager?

[ebarticel]

Hi Scott,

Is this homework question?

[98765432110A]

No it snt

[Julio Carvajal]

Hello Scott,

The Router will be the layer 3 device doing the routing here, you need to configure sub-interfaces ( over the interface connected to the trunk link on the switch) for each vlan ( so 2 on this case).

Just by doing that you will be allowing traffic from one vlan to the other one.

Regards,

Julio

Please rate helpful posts!!

[Neeraj Arora]

Hi Scot,

As Julio mentioned, Router would have to be configured with sub-interfaces and you'd have to implement a router-On-a-stick scenario

I came across the following document:

** Configuring InterVLAN Routing and ISL/802.1Q Trunking on a Catalyst 2900XL/3500XL/2950 Switch Using an External Router

http://cisco.com/en/US/customer/tech/tk389/tk815/technologies_configuration_example09186a00800949fd.shtml

Its and old document but it does explain well the setup you are trying to create along with the configuration example.

Hope it helps.

Neeraj

[ebarticel]

Hi Scott,

As Julio an Neraj mentioned you have to create router-on-a-stick, you have to configure switch with trunk link to router, then you need to create a voice vlan as well on the switch port that connects to IP phone/clients PC (I guess that you mean by clients/phone manager).

I hope this helps

Eugen