Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing Internet-traffic to our Proxy Server?

Our wireless devices pick-up a 10.20.*.*/16 address. Is a port-forwarding device available to sit behind an Access-Point and transparently route all Internet traffic to our 10.3.1.xx Proxy Server? Ideally, this should be configurable to not re-route any Internet port for any IP on our Intranet.

Help appreciated. Thanks, Mark.

1 REPLY
Green

Re: Routing Internet-traffic to our Proxy Server?

You need a router or other L3 device to do the routing. You could do some Policy-Based Routing to make the decision for Proxy/No Proxy depending on the port and destination address.

The clients may need to have their computers/devices set to point to the proxy (depending on the proxy and how you have it set up).

There are "Captive Portal" systems that will intercept all new connections for authentication, but I'm not sure that you can have them route to a specific interface once the authentication has been accomplished.

Cisco's Captive Portal is "BBSM," there are some other Open-Source systems .... hit Google for "nocat" or "captive portal" to get the list.

Good Luck

Scott

637
Views
0
Helpful
1
Replies
CreatePlease to create content